Clutch Warranty and Procedure

BMD WARRANTY POLICY

CLUTCH PLATES & COVER ASSEMBLIES:
One year against defective parts and workmanship. Parts will be replaced and labor will be allowed using a flat rate from the I&T Manual as a guideline multiplied by 80% of the shop rate. Please contact US Farm Parts (800-851-3014) to obtain a RGA (Return Goods Authorization) number prior to returning any parts for warranty evaluation. A shop ticket along with a copy of the invoice must be included with the returned warranty part.

No parts or labor will be allowed on:
Burned levers or bent clutches / and or pressure plates.
Oil or grease contaminated pressure plates or disks.
Disk and pressure plate assemblies with damaged hub splines.
Damaged parts due to improper flywheel condition.
Overloading or abuse.

Labor Rate Schedule for all T/A applications:
$500 flat rate for the first year
$425 flat rate for the second year
$350 flat rate for the third year
$275 flat rate for the fourth year
$200 flat rate for the fifth year

Oil and gaskets are not covered. Warranty does not cover broken oil rings or bent/ distorted lube baffles which were damaged during installation. Warranty coverage applies to defects in materials and/or workmanship only.

LUK AGRICULTURAL CLUTCHES

LUK guarantees that its products are free from defects in both workmanship & materials for a limited period of one year or 1,000 hours whichever comes first, provided the clutch, disk, release bearing and pilot bearing are properly replaced and the flywheel is properly resurfaced or replaced.

LUK reserves the right to inspect any products in question and to make a judgement on the warranty claim. Product returned for a warranty claim must be returned to the distributor from which it was purchased.

CORE POLICY:

Some BMD and LuK clutch disks, pressure plates, torque amplifiers, and PTO shafts are sold with a core charge. Core charges are credited as soon as the core is returned.

In order to receive prompt core credit, please do the following:

1. Put the core back in the box.
2. Take the A.R.S. label out of the packing slip pouch and put it over the original label.
3. Seal the box.
4. Give the box to your UPS driver.

There is no freight charge for the return of your core.

NOTE: ARS tags are provided for core returns only unless sent specifically with the issuance of a RGA.

Cores returned in pieces or broken are subject to no or partial core credit.